114
ERROR MESSAGES AND CORRECTIONS
CHAPTER 11
MAIN SHAFT MOTOR
NO. CORRECTIONMEANINGERROR MESSAGE
Position Error
Main Motor Driver
Overload
Trimming System
Right Bar Switch
Left Bar Switch
Head Cover Open
100
101
102
103
104
105
106
Main shaft does not stop at 100
degrees when machine stops.
Error of the main shaft motor
driver.
Thread is tangled, needle bar
reciprocator is defective, thread
is entangled when it trims.
Thread trimming sensor does
not return home after trim.
Start button is pushed down
when machine is turned on.
Start button is pushed down
when machine is turned on.
Safety Cover of tension
adjusting plate open.
Use degree wheel to move shaft
angle to 100 degrees
Turn main switch off and then
turn it on again.
Check the hook and then turn
the main switch off and back on
again.
Check operation of thread
trimmer.
Check to see if contact is being
made by start button.
Check to see if contact is being
made by stop button.
Make sure to black plastic
safety cover is closed.
To Next Page
Loading...
Need help?
General
