SunStar SWF/B-T1201C - CHAPTER 5 BASIC MACHINE OPERATION

20
BASIC MACHINE OPERATION
CHAPTER 5
TURN ON THE MAIN SWITCH
IS THE OPERATING SYSTEM INSTALLED?
IS THE DESIGN INPUT KEY PRESSED?
ARE THERE PREVIOUSLY WORKED DESIGNS?
READ IN DESIGN IS THE SAME SET-UP BEING USED?
INSTALL THE OPERATING SYSTEM
ARE THERE DESIGNS INSTALLED IN MEMORY?
READ DESIGNS IN USING FLOPPY DISK OR TAPE
SELECT A DESIGN
SET-UP PARAMETERS OF THE DESIGN
SELECT NEEDLE BARS (COLORS)
DO YOU WANT REPETITION OF DESIGN?
POSITION WORK
DO YOU WANT ANY FRAME OFFSET?
PUSH START BUTTON
DO YOU WANT AUXILIARY WORK?
PERFORM AUXILIARY WORK
SET UP REPEAT WORK
SET UP FRAME OFFSET
YES
YES
YES
YES
NO
NO
NO
NO
NO
YES
YES
YES