84
EMBROIDERY DATA SET-UP
Press when the operating system loads. There are three auxiliary menus in the data setup
EMB FUNCTION : Sets up the parameters for the embroidery work.
MACHINE FUNCTION : Sets up the parameters for the machine operation.
DEFAULT : Sets all your embroidery functions and machine functions to the factory settings.
If you are not sure where your settings should be scroll down to DEFAULT and press SET.
To set up the parameters, move the cursor to the chosen parameter. Use the numerical keys to enter the data.
The set-up data will be stored automatically when you press
EMB FUNCTION
TOTAL STITCH CLEAR: (Total number of stitches)
Along with TOTAL ST from the main function menu, this function indicates the number of stitches (1
number for each stitch) performed from the beginning and is also used to go back to the beginning set-up
data. (Only the numerical key 0 works here.)
TOTAL WORK CLEAR: (Total number of table set) Along with TOTAL WK from the main function
menu, this function indicates the number of table sets ( the selected design finished once) by 1 for each.
(Only the numerical key 0 works here.)
JUMP CONVERT: (Trimming after jumps) This function trims and moves the frame if the jump function
is repeated more than the number of times in the set-up. Example: If the number of repetition in the set-up is
5, during embroidery work that includes a jump code, the jump stitch is performed on the fourth stitch
without trimming. After more than 4 stitches the work resumes after trimming and moving 5 stitches. The
default is 3. Set-ups are possible from 0~10 stitches in increments of 1 stitch.
AUTO ORIGIN: (Return to the starting position) This function returns the frame to the starting position
after the selected design has been finished. The default is YES. If AUTO ORIGIN is not desired, input ‘0’
to select NO.
1] TOTAL STITCH CLEAR
2] TOTAL WORK CLEAR
3] JUMP CONVERT:3st
4] AUTO ORIGIN:YES
To Next Page
Loading...
