SunStar SWF/B-T1201C - Page 93

87
TRIM LENGTH: (Length control of the thread tail after trimming) Determines the length of the upper
thread left on the needle after automatic trimming. The default is medium length. To setup for SHORT enter
(0), and for LONG enter (2).
AUTO TRIM: (Automatic trimming) Determines whether or not to have the automatic trimming function
operated. The default is YES. To turn OFF the automatic trimming function, select NO.
AUTO C/C: (Automatic color changing) Determines whether or not to operate the automatic color changing
function. The default is YES. To turn OFF the automatic color changing function, select NO.
MAX SPEED: (Limit of the maximum speed) Determines the maximum machine speed. The default varies
according to the machine type and the goods being embroidered. The range is shown below, and the
increment is 10rpm.
MIN SPEED: (Minimum speed limit) Determines the minimum embroidery speed. The default speed is 300
rpm, and the speed can be varied from 300 rpm to the maximum speed with an increment of 10 rpm.
JUMP SPEED: (Speed of jump stitches) The setup of jump stitch (the frame moves without sewing) speed
limit. The standard speeds 750 rpm. The limit can be setup from the minimum speed to the maximum speed
in increments of 10 rpm.
SWF/󱅢-T1201C
SWF/󱅢-T901C
SWF/󱅢-T601C
1200
1200
1200
1200
1200
1200
TUBULAR CAP
Type
Sewing Materials
CAUTION
If the jump stitch exceeds 750 rpm, broken needles and mechanical problems
with the needle bar can occur.