Troubleshooting
I f you have any questions, please consult the troubleshooting guide below.
Make sure the Main unit s POWER button is on
Ensure the remote batteries are working.
Point the remote control directly at the player s IR
sensor.
Remove any obstacles between the remote and the
IR sensor.
Turn off the power and then turn it on again.
Ensure the disc is not warped, damaged or deformed.
Ensure the disc is not badly stained or damaged.
Ensure the disc format is compatible with the player.
Please check whether you have tried to play a software CD.
If so, please restart the player.
Ensure you have put the disc on the tray.
Ensure the disc is not upside down.
Ensure the disc is not distorted, stained or scratched.
Ensure the power button is on.
Ensure the power outlet is operational.
Ensure the power cord is not damaged.
Ensure the power plug is connected firmly to the outlet.
Ensure the audio jacks are securely connected..
Ensure the audio connector is not damaged.
Ensure the volume is turned up in VOL/CH setup.
Ensure you have set the player s AUDIO settings correctly.
Ensure you have entered the correct AV input for your TV.
Ensure the audio is not set to mute.
Ensure the video jacks are securely connected.
Ensure you have entered the correct AV input for your TV.
Ensure the video connector is not damaged.
Ensure you have set the player s VIDEO settings correctly.
Ensure you have set the player s AUDIO settings correctly.
Ensure the disc is not scratched or stained.
Ensure the AV connector or the output terminal is not
damaged.
NO PICTURE OR SOUND BAD DISC DISPLAYED
REMOTE NOT WORKINGPICTURE BUT NO SOUND
SOUND BUT NO PICTURE UNIT NOT WORKING
POOR PICTURE OR SOUND NO DISC DISPLAYED
43
To Next Page
Loading...
