Sunvision Scientific 28LXT - Replacing Lamps

Removing/Replacing Lamps
After removing the acrylic shield, replace lamps as follows:
Step 1. Grasp the lamp at one end and at the middle, then turn the
lamp a quarter turn. The lamp may then be gently removed
from its holder.
Step 2. To re-install a lamp, insert the pins located on the ends of the
lamp into the slots on top of the lamp holder and turn the
lamp a quarter turn.
Recommended Replacement Lamps
Do not use lamps other than those specified below. Using uncertified lamps is a
violation of Federal regulations and will void your warranty. These lamps have an
average life of 800-1000 hours of effective tanning use. Lamps used longer than that
begin to lose their effectiveness even though they will continue to light.
Pro 28LXF
Pro 28LX2F
Pro 24SF
Pro 24ST
Pro 28LXT
Pro 24S
Pro 28LX
Lamp Model Number
Diamondsun S Wolff Model 71T12100W
Application
Canopy and Bench
Application
Canopy and Bench
Turbo Face Tanner
Lamp Model Number
Diamondsun S Wolff Model 71T12100W
Turbo Sun S Wolff Model F8-T5-10W
Application
Canopy and Bench
Facial Unit
Lamp Model Number
Diamondsun S Wolff Model 71T12100W
Philips Model HPA 400/30s
Cosmo Tech Model 23045
Cosmo Tech Model 20046
15
Care & Maintenance-Replacing Lamps
Lamp Model Number
Diamondsun S Wolff Model 59T12080W
Diamondsun S Wolff Model 71T12100W
Philips Model HPA 400/30s
Cosmo Tech Model 23045
Cosmo Tech Model 20046
Application
Canopy and Bench
Facial Unit
Only the following lamp types have been certified for use in SUNVISION Solariums