16
Care & Maintenance-Replacing Lamps
Removing/Replacing Face Tanner Lamp on F Models
After removing the canopy acrylic shield, replace the face tanner lamp as follows:
Step 1. Support the face tanner assembly with your hand while
unscrewing the two retaining screws. The face tanner glass
casing will now swing downward.
Step 2. The lamp can now be exchanged. The lamp holders are
equipped with spring contacts which enables the lamp to be
removed easily. Remove the old lamp and discard. Install the
new lamp, using a clean cloth or paper towel. Ensure that the
lamp is firmly seated in the lamp holders.
Note! Never take hold of the lamp such that your fingers are in
contact with the lamp glass. Finger oils will greatly reduce the
lamp’s operational life.
Step 3. Gently close the face tanner glass casing and lock it closed with
the screws. Ensure that the screws firmly secures the glass casing.
Warning! Never turn the equipment on while the face tanner is disassembled or
when the glass filters have been removed. The direct light can cause severe injury to
the eyes and to other areas of the body. Immediately discontinue use of this
equipment if the face tanner glass is broken or if any unfiltered light can be seen
escaping the face tanner assembly.
RETAINING
SCREWS
To Next Page
Loading...
