SUPAIR Strike - Reserve parachute;risers.

Harness User’s manual
SUP’AIR _STRIKE_ Page 15
1. - Open the 7mm square
Maillon Rapide®.
- Connect the reserve para-
chute single riser loop. la
fixer avec un joint torique.
- Push the maillon through
the plastic ring
- Twist
3. - Give a second twist to
the plastic ring.
- Push the buckle through
the maillon.
2. - Push the end riser
through the toric ring.
- Push the maillon through
the risers buckles.
4. - If you use separate/in-
dependente risers Repeat
steps 1 through 3 with the
second riser.
- If you use separate risers
>> Reserve parachute/risers.
5. - Tidy up the assembly.
- Be certain for the riser end
loops to be securely fas-
tened.
- Close the Maillon Rapide®
tightly by hand.
- Tighten using pliers and
making a ¼ turn.
One (1) square 7mm Maillon Rapide® will be needed + two (2 flexible toric rings.
>> Position the risers
- Place the risers inside their guiding/protective
sleeve connected alongside the harness.
- Push them through and under the zipper tab.
- Bring them out through the reserve container.
- Close the Zip to the tab above the left shoulder.
- Fasten the Velcro® located at the end of the
sleeve.
Reserve parachute/harness connection.
A
A
Closing direction.
Installing the reserve parachute.