Harness User’s manual
SUP’AIR _STRIKE_ Page 20
Connecting the wing to the harness.
Connecting the wing to the harness.
Install the accelerator by following the previous ins-
tructions.
Connect it to the wing using the split hooks.
Once the accelerator/speedbar is connected adjust
its length according to the wing recommended mea-
surements.
Installing the accelerator.
Without twisting the risers, connect them to the har-
ness attachment loops using the self-locking carabi-
ners.
The connection wing/harness can be done using
either standard self-locking carabiners or a set of
SUP’AIR «Connects» ( ultralight flexible Dyneema
connectors ).
Check for the risers to be properly positioned and
untwisted. The «A» risers must be located at the front
and facing the flight direction (see diagram).
Lastly, check for the main self-locking carabiners to
be fully closed and locked in place.
1
3
5
2
4
6
7 8
Harness
Flight
direction.
Twist Lock Carabi-
ners
Connects
« A » risers
left side.
Self-locking
carabiners.
For correct use there
must not be any line
tension at the split hook
level when the accelera-
tor/speedbar line is fully
relaxed.
To Next Page
Loading...
