13
Installing the reserve parachute in its pocket.
Thank you for comprehensively reading the following ! We will re-
commend you to have your reserve parachute initially instal-
led by someone competent and familiar with the procedure.
1 / Insert the reserve parachute inside the harness
parachute pocket by opening all the aps. The
POD must be positioned with the handle at the top
with risers and lines at the bottom. Push the risers
through the guiding sleeves ( the risers must be
located behind the parachute ).
1
3
2
4
Push a piece of cord through
the line loop #1
Push the cord through the grommets 2 and
3 and pull it to force the line loop through
the grommets.
Push the handle’s yellow cable ( front sec-
tion ) through line loop #1. Then delicately
remove the cord from the underside of the
loop.
The reserve parachute pocket vo-
lume is variable in size.You rst
must adjust its volume according to
that of your reserve parachute size.
With the furthest pocket inner ap setting :
the reserve parachute pocket offers maxi-
mum capacity to accept standard solo para-
chutes.
With the inner ap setting positio-
ned atop the velcro at the pocket
center : the volume is reduced and
will accept the reserve parachute
X-Light.
Adjustable reserve parachute pocket.
Reserve parachute installation in its pocket.
To Next Page
Loading...
