● Use one hand to hold the handle, and use the other hand to pull
the lock pin knob (C) and turn it anticlockwise. Then fold the
handle down until you hear the “click” of the locking pin fitting into
position on the main frame.
- 31 -
CHARGE BATTERY
● When you get your new battery put it on charge for at least 24 hours.
● When recharging your battery, always charge for at least 12 hours
or until the light on the charger turns green. It is best to charge for
at least another hour after the light turns green.
● Never use the battery for any purpose other than to power your
scooter.
● The battery charger can become hot during charging so your
charger should be placed in a suitable place with good air flow
and away from children.
To recharge the batteries,
follow the steps below:
● Place your Scooter close to
a standard
electrical
wall outlet.
● Turn the scooter key switch
to the “Off” position.
● Plug the charger power
cord (Round plug) into the
socket indicated on
scooter. (N)
● Plug the charger power plug
into a standard wall outlet.
● When charging is completed,
the yellow LED will turn to green.
● Disconnect the charger power cord from the wall outlet and the
plug from the scooter when the batteries are fully charged.
● NOTE: The battery connector L1 must be connected to L2 for
charging.
- 32 -
To Next Page
Loading...
