Supelco Spectroquant Prove Series - Connecting the Power Supply; First Power-on and Boot Process

Version 2.0 – 08/2018
12
4
5
3
2
1
3 Getting Started – 3.2 Initial Setup
Connecting the power adapter:
1. Connect the miniplug
1
of the power adapter
to the socket
2
of the spectrophotometer.
2. Connect the power adapter to a wall socket.
3.2.2 First Power-on
After switching on the spectrophotometer for the
first time you are automatically guided through
the language, date and time setup procedures.
1. Press the ON/OFF button
1
. The spectro-
photometer gives an audible signal (beep)
and starts booting for approximately 2 min-
utes. You will see the following display:
2. The display switches to language setup (see
section 3.2.3).
1
2
1
3