Great Circle USA
Support Line: 1-866-493-0524
help@greatcircleus.com
www.greatcircleus.com
MAINTENANCE AND STORAGE
1. Always shut off the power source while repairing or adjusting the splitter except as recommended by the manufacturer.
2. Clear debris from movable parts, but only when the power source is shut off.
3. Check to be sure all nuts and bolts are tight to assure the equipment is in safe working condition prior to each usage, and
periodically during usage. Electromotor vibration may shake screws and bolts loose during operation.
TROUBLE SHOOTING
Problem
Electromotor will not start.
Electromotor starts but runs loudly.
Wedge movement is slow or erratic.
Oil leak from cylinder.
Wedge will not extend or retract.
The hose is twisted after tightening.
The valve stem springs back multiple
times.
Cause
No electricity.
No plug in.
Power switch is OFF.
Something in the motor.
Motor cover interferes with vane.
Air in the hydraulic oil system.
Debris lodged in beam guides.
Low hydraulic oil.
Faulty cylinder rod seal.
Scored or bent cylinder rod.
Loose hydraulic fitting.
Hydraulic oil is not continuous.
Faulty combination washer seal
on cylinder hydraulic fitting.
Faulty control valve.
Faulty hydraulic pump.
Low hydraulic oil.
The hose rotates.
There is air in the hydraulic hoses.
Solution
Waiting for electricity.
Plug in.
Turn on the power switch.
Remove impurity.
Adjusting motor cover.
Purge air by extending and retracting the wedge
several times until motion is smooth.
Clear the filter net from beam.
Check oil level and add as needed.
Contact Customer Service.
Contact Customer Service.
Tighten hydraulic fitting.
Add hydraulic fluid.
Clear the filter net from beam.
Contact Customer Service.
Contact Customer Service.
Check oil level and add as needed.
Inflate tires to proper pressure. Refer to tire
Clamp the hose sleeve with pipe pliers and tighten
the joint with a wrench.
Unscrew oil dipstick to vent.
Size: 210x285mm REV 11/09/21 3.02.01.273 157克双铜
11
To Previous Page
Loading...
