10
1. HANDLEBAR INSTALLATION
A. Use the 5 mm hex wrench to remove the bolts from the handlebar clamp.
B. Once the clamp is open, place the lower crossbar of the handlebar in the
groove of the top crown.
C. Loosely tighten the handlebar clamp with the 5 mm hex wrench, and adjust
the angle of the handlebar to rider’s comfort.
D. Cross-tighten the handlebar clamp from corner-to-corner making sure the
clamp is tight and handlebars do not move.
ASSEMBLY INSTRUCTIONS
DANGER !
Do NOT ride your Super73 if it has been assembled incorrectly. Riding an incorrectly
assembled bike can put your own safety at risk as well as others. Before your first
ride, perform the pre-ride safety check on pg. 5.
A
C D
B
To Next Page
Loading...
