12
4. HEADLIGHT INSTALLATION
A. Locate the two headlight mounting screws, remove the two mounting screws
from the crown, and set aside.
B. Align the headlight mounting bracket with the two holes on the top fork crown,
and loosely tighten the mounting screws back in place.
C. Using a 5mm allen wrench, tighten the mounting screws in place to secure the
headlight to the crown.
D. Once headlight is installed, connect the yellow higo plug to controller by
aligning arrows on both ends and pushing into place. The headlight is ready for
use.
A
C
D
B
To Next Page
Loading...
