14
VIEWING GAUGES
STEP 1 - Enter the
Scan Menu.
STEP 2 - Select
Gauges/Datalog.
STEP 3 - If asked,
turn ignition on,
but do not start.
STEP 4 - Follow
the on-screen
instructions.
STEP 5 - Select a PID Group, then select
a total of 4 PIDs. Use the / arrows to
switch between screens. OK to select.
While viewing gauges,
press OK to start
Datalogging
Press OK again to stop
Datalogging
Press OK to continue
STEP 6 - Follow the on-screen
instructions. Note the RED highlights.
See DataLogging for more information.
Select 4 PIDs within the
following PID groups
Press OK to continue...
PID Groups
Engine Misc
Fuel Trim/Press
Time/Distance
Oxygen Sensors
Misc Non-Engine
Egr/Evap
Catalyst Temp
Throttle Detail
Engine Misc
Calc Eng Load
Engine Coolant Temp
Manifold Abs Pressure
Engine RPM
Spark Advance
Intake Air Temperature
Mass Air Flow
Abs Throttle Position
GAUGES / DATALOG
If you would like to view Parameter IDs (PIDs) specic to your vehicle, following these
instructions to learn how to view them using your Flashcal device.
Do not exceed legal speed limits on public roadways.
WARNING
To Next Page
Loading...
