EasyManua.ls Logo

Superior Fireplaces DRT2035TMN-C - User Manual

Default Icon
80 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
- Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Leave the building immediately.
• Immediately call your gas supplier from a neigh-
bor’s phone. Follow the gas supplier’s instruc-
tions.
• If you cannot reach your gas supplier, call the
fire department.
- Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly could
result in serious injury, death, or property damage.
AVERTISSEMENT:
RISQUED’INDENDIE OU D’EXPLOSION
Le non-respect Des avertissements de sécurité
pourrait d’entraîner des blessures graves, la mort
ou des dommages matériels.
- Ne pas entreposer ni utilizer d’essence ni d’autres
vapeurs ou liquides inflammables dans le voisinage
de cet appareil ou de tout autre appareil.
- QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
• Ne pas tenter d’allumer d’appareil.
• Ne touchez à aucan interrupteur. Ne pas vous servir
des téléphones se trouvant dans le bâtiment où
vous trouvez.
• Sortez immédiatement de bâtiment.
• Appelez immédiatement votre fournisseur de
gaz depuis un voisin. Suivez les instructions du
fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service des incindies.
- L’installation et l’entretien doivent être assurés par
un installateur ou un service d’entretien qualifié
ou par le fournisseur de gaz.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future
reference.
Installateur : Laissez cette notice avec l’appareil.
Consommateur : Conservez cette notice pour
consultation ultérieure.
This appliance may be installed in an aftermarket permanently located, manufactured home (USA only)
or mobile home, where not prohibited by local codes. This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is not convertible for use with other gases, unless a certified kit
is used.
Cet appareil peut installé dans une maison préfabriquée (mobile) déjà installée à demeure, si les réglements
locaux le permettent. Ce appareil doit être utilisé uniquement avec le type de gaz indiqué sure la plaque
signalétique. Cet appareil ne peut être converti à d’autres gaz, sauf si une trousse de conversion est utilsée.
Installation and Operation Instructions
Models
CU
S
Report No. F13-094
Ce manuel est disponible en francais, simplement
en faire la demande. Numéro de la pièce 900948-02
P/N 900948-00 REV. C 06/2019
DRT2000-C Series Direct-Vent Gas Fireplaces
P900948-00
DRT2040REN-C
DRT2040REP-C
DRT2040RMN-C
DRT2040RMP-C
DRT2040TEN-C
DRT2040TEP-C
DRT2040TMN-C
DRT2040TMP-C
DRT2035REN-C
DRT2035REP-C
DRT2035RMN-C
DRT2035RMP-C
DRT2035TEN-C
DRT2035TEP-C
DRT2035TMN-C
DRT2035TMP-C
DRT2045DEN-C
DRT2045DEP-C
DRT2045DMN-C
DRT2045DMP-C

Table of Contents

Other manuals for Superior Fireplaces DRT2035TMN-C

Preview: Installation And Operation Instruction Manual
Installation And Operation Instruction Manual80 pages

Questions and Answers

  • S
    Susan AustinAug 13, 2025
    Why is pilot burning but no gas to burner on Superior Fireplaces DRT2035TMN-C?
    • M
      Michael SalasAug 13, 2025
      If the pilot light is on, the valve knob is in the 'ON' position, and the burner switch is also 'ON' but there's no gas to the burner of your Superior Fireplaces Indoor Fireplace, there are several potential causes. First, the wall switch or its wiring might be defective; check connections or try a jumper wire. Second, the thermopile might not be generating enough millivolts; it should read a minimum of 325 millivolts with the switch off. Third, the burner orifice could be plugged, so inspect and clear any blockages. Finally, if using a remote switch, ensure the standard switch is OFF to prevent excessive resistance.
  • R
    Rebecca FrederickAug 17, 2025
    How to fix spark igniter that won't light pilot on Superior Fireplaces DRT2035TMN-C Indoor Fireplace?
    • Y
      youngchadAug 17, 2025
      If the spark igniter on your Superior Fireplaces Indoor Fireplace fails to light the pilot after repeated attempts, it could be due to several reasons. First, the igniter itself might be defective; check for a spark at the electrode. If there's no spark and the electrode wire is connected correctly, consider replacing the igniter. Second, the electrode might be misaligned; try lighting the pilot with a match. If it lights, the gas mixture might be the problem. If it still doesn't light, check the gap at the electrode; it should be 1/8 inch. Finally, the gas supply pressure could be incorrect, or the pilot orifice may be blocked; ensure the gas pressure is within the specified limits and clean or replace the pilot orifice.
  • R
    rvincentAug 21, 2025
    What to do if Superior Fireplaces DRT2035TMN-C Indoor Fireplace has frequent pilot/burner outage?
    • M
      Mrs. Anne Wood DDSAug 21, 2025
      If you're experiencing frequent pilot/burner outages with your Superior Fireplaces Indoor Fireplace, it might be because the pilot flame is too low or too high, causing the pilot/valve safety to shut off. You should clean and/or adjust the pilot flame to ensure maximum flame impingement on the thermocouple.
  • S
    Shelley GayAug 25, 2025
    Why pilot will not stay lit on Superior Fireplaces DRT2035TMN-C?
    • A
      anthony88Aug 26, 2025
      If the pilot light won't stay lit on your Superior Fireplaces Indoor Fireplace, even after following the lighting instructions, the pilot generator (thermocouple) could be defective. Ensure the pilot flame is correctly hitting the thermocouple. Clean and/or adjust the pilot for maximum flame impingement on the thermocouple. Also, make sure the connection between the valve and thermocouple is tight and secure.
  • R
    Raymond HuffmanAug 28, 2025
    Why won't the pilot light stay lit on my Superior Fireplaces Indoor Fireplace?
    • E
      Elizabeth AndrewsAug 28, 2025
      If the pilot light on your Superior Fireplaces Indoor Fireplace won't stay lit, make sure the pilot flame is hitting the thermocouple. You may need to clean and adjust the pilot for better flame contact. Also, check that the connection between the valve and thermocouple is tight and secure.
  • W
    William JohnsonSep 1, 2025
    How to fix a spark igniter that won't light the pilot on my Superior Fireplaces Indoor Fireplace?
    • R
      ruizrobertSep 1, 2025
      If the spark igniter on your Superior Fireplaces Indoor Fireplace isn't lighting the pilot, first check for a spark at the electrode and pilot. If there's no spark and the electrode wire is connected correctly, the igniter may be defective and need replacement. If there is a spark, try lighting the pilot with a match. If it lights, the gas mixture might be off, so allow for a longer purge. If it still doesn't light, check the gap at the electrode and pilot; it should be 1/8 inch for a strong spark. If the gap is correct, the pilot might need replacing. Also, check the inlet gas pressure to ensure it's within the limits marked on the rating plate, and inspect the pilot orifice for any blockages, cleaning or replacing it if necessary.
  • C
    Christopher HooperSep 8, 2025
    Why does my Superior Fireplaces Indoor Fireplace frequently have pilot/burner outages?
    • F
      fbaileySep 9, 2025
      If you're experiencing frequent pilot/burner outages with your Superior Fireplaces Indoor Fireplace, the pilot flame might be too low or too high, causing the pilot/valve safety to shut off. Try cleaning and adjusting the pilot flame to ensure it properly impinges on the thermocouple.

Summary

SAFETY AND YOUR FIREPLACE

IMPORTANT SAFETY INFORMATION

Crucial warnings and guidelines for safe operation and handling of the fireplace.

APPLIANCE INSTALLATION, SERVICE, AND MAINTENANCE NOTICES

Notices related to proper installation, service, and maintenance procedures.

INSTALLATION

PACKAGING

Lists all items included in the fireplace package.

INTRODUCTION

Provides an overview of the fireplace features and general installation notes.

Codes and Standards

Details compliance with national and local safety codes and standards.

BTU Input

Specifies the input rate in BTU/HR for different models and gas types.

Gas Pressure

Details required inlet and manifold outlet gas pressures for proper operation.

Orifice Sizes-Sea Level to High Altitude

Lists correct burner orifice sizes for various altitudes.

COMMONWEALTH OF MASSACHUSETTS REQUIREMENTS

Lists specific installation requirements for Massachusetts.

MANUFACTURED HOME REQUIREMENTS

Details installation requirements for manufactured and mobile homes.

LOCATION

Discusses considerations for selecting a proper location for the fireplace.

VENT TERMINATION CLEARANCES

Specifies minimum clearance requirements for vent terminations.

MINIMUM CLEARANCES TO COMBUSTIBLES

Outlines minimum clearances required around the fireplace and vent components.

INSTALLATION PREPARATION

Steps to take before installing the fireplace unit itself.

INSTALLATION SEQUENCE

Outlines the typical step-by-step process for installing the fireplace.

OPERATION

Burn-in Period

Describes the initial operation period and associated odors or haze.

Accessing the Control Compartment

Instructions on how to open and access the fireplace's control compartment.

Install the Logs and Glowing Embers

Step-by-step guide for correctly positioning logs and embers for proper flame appearance.

Installing and removing the glass door

Procedures for safely installing and removing the fireplace's glass door.

Superior Fireplaces DRT2035TMN-C Specifications

General IconGeneral
ModelDRT2035TMN-C
CategoryIndoor Fireplace
TypeDirect Vent
Fuel TypeNatural Gas
Weight120 lbs
Ignition TypeElectronic
VentingDirect Vent

Related product manuals