Installation
900004-00, 04/2014
Innovative Hearth Products
Superior™ DRT2000 and DRC2000 Direct-Vent Gas Fireplaces
44
Table 32: Listed Secure Flex
®
Components
H1969 SF4.5HT-2
Horizontal Square Termination for
flex (without flex)
56L74 SFVT30
Vertical Termination for flex (flat to 6/12)
with flex adaptor, section of rigid vent, roof
support collar assembly, roof flashing and
storm collar. (see 750052M)
77L87 SFKIT12S
Square Term. for flex with
12” (305 mm)* compressed flex
77L88 SFKIT18S
Square Term. for flex with
18” (457 mm)* compressed flex
77L89 SFKIT24S
Square Term. for flex with
24” (610 mm)* compressed flex
56L75 SFVT45
Vertical Termination for flex (6/12 to 12/12)
with flex adaptor, section of rigid vent, roof
support collar assembly, roof flashing and
storm collar. (see 750052M)
77L90 SFKIT36S
Square Term. for flex with
36” (914 mm)* compressed flex
H7748 H7748
36” Flex Connector Kit.
36” of flex with two adaptors for
mating two rigid sections of vent
together.
77L91 SFKIT48S
Square Term. for flex with
48” (1219 mm)* compressed flex
91L66 SFGC4-6
Gear Clamp 4.5” (114 mm) for flex
(6-pack)
91L67 SFGC7-6
Gear Clamp 7.5” (190.5 mm) for
flex (6 pack)
*All compressed flex vents can be expanded up to two times.
GAS CONVERSION KITS
WARNING
This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s
instructions and all applicable codes and requirements of the authority having jurisdiction. If the
information in these instructions is not followed exactly, a fire, explosion, or the production of carbon
monoxide may result; causing property damage, personal injury, or loss of life. The qualified service agency
is responsible for the proper installation of this kit. The installation is not proper and complete until the
operation of the converted appliance is checked as specified in the manufacturer’s instructions supplied with
the kit.The qualified service agency performing this installation assumes responsibility for this conversion.
AVERTISSEMENT
Cette trousse de conversion doit être installée par un technicien agréé, selon les instructions du fabricant
et selon toutes les exigences et tous les codes pertinents de l’autorité compétente. Assurez-vous de bien
suivre les instructions dans cette notice pour réduire au minimum le risque d’incendie, d’explosion ou la
production de monoxyde de carbone pouvant causer des dommages matériels, des blessures ou la mort.
Le tecnicien agréé est responsable de l’installation de cette trousse. L’installation n’est pas adéquate ni
complète tant que le bon fonctionnement de l’appareil converti n’a pas été vérifié selon les instructions du
fabricant fournies avec la trousse. Le fournisseur de service qualifié ayant réalisé l’installation assume les
responsabilités liées à la conversion.
In Canada:
The conversion shall be carried out in accordance with the requirements of the provincial authorities having
jurisdiction and in accordance with the requirements of the CAN/CGA-B149.1 Installation code.
La conversion devra être effectuée conformément aux recommandations des autorités provinciales ayant
juridiction et conformément aux exigences du code d’installation CAN/CGA-B149.1.
Gas conversion kits are available to adapt your fireplace from the use of one type of gas to the use of another. These
kits contain all the necessary components needed to complete the task including labeling that must be affixed to
ensure safe operation.
Refer to the instructions provided with the conversion kit when performing any gas conversion.
Tabl e 33: Millivolt Systems,Natural Gas To Propane Gas Conversion Kits Ta ble 34: Millivolt Systems, Propane Gas to Natural Gas Conversion Kits
Models Catalog Number Models Catalog Number
DRC2033 / DRT2033 F1893 DRC2033 / DRT2033 F1891
DRC2035 / DRT2035 F1771 DRC2035 / DRT2035 F1769
DRC2040 / DRT2040 F1772 DRC2040 / DRT2040 F1770
DRC2045 / DRT2045 F1897 DRC2045 / DRT2045 F1895
To Next Page
Loading...
