10
NOTE: The fast lever should be in the upright position for installation of the sanding unit. The fast lever raises the inboard
(right) side of conveyor up. Do not ever tighten the bolts all the way down. The fast lever should always be able to be moved
back and forth between and up/down position. The bolts should be tightened, but not so tight that the fast lever doesn’t
move. The lever should be able to move from the down to up position easily.
heads (or hex head bolts) and install into flange of
conveyor bed on inboard (right) (motor side). Keep
support plate in place on inboard (right) side and make
sure the fast lever is positioned up.
Plug the short power cord that is attached to the mo-
tor into the outlet on the control box. This cord will pro-
vide switched power for the motor when the machine
is plugged into the power source.
studs on outboard (left) side of the conveyor belt, then
tighten all nuts and bolts with wrench.
NOTE: Do not completely tighten bolts with fast lever. See
note above.
Check your power supply to make sure that it is ade-
quate (110 V, 20 A required) but do not plug the ma-
chine into the power supply until it is fully set-up.
11
13
12
14
To Next Page
Loading...
