7
19-38 DRUM SANDER OWNER’S MANUAL Quick Set Up Guide to Unpacking
Cut each corner of BOX 1 to fold sides flat,
providing access to sanding unit.
Remove the two wooden packing plates
from bottom of the sanding unit. Attach se-
curely, use the enclosed wrench to tighten
and keep wrench for future adjustments.
3 5
4
6
NOTE: BOLTS
These bolts that you just removed
from the packing plates will work
as your bolts for attaching the
sander or as extra bolts for fu-
ture replacement.
With one or two helpers, place the sanding
unit on stand or bench.
Install knob to height adjustment handle.
First, finger tighten nut to knob. Thread
stud from knob into hand wheel and tight-
en nut against hand wheel.
Lift points marked.
To Next Page
Loading...
