A+ Server AS -1024US-TRT User's Manual
32
11. Lower the heatsink down till it rests securely on CPU Package over the four screw
holes on the socket frame.
12. Using a diagonal pattern and a Torx T20 driver, tighten the four heatsink screws evenly
to 16.1 kgf-cm (14.0 lbf-in) of torque.
The processor and heatsink installation is complete. Repeat this procedure for any remaining
CPU sockets on the motherboard.
#1 Screw
#2 Screw
#3 Screw
#4 Screw
Figure 3-11. Securing the Heatsink
Figure 3-10. Mounting the Heatsink
To Next Page
Loading...
