C-4
Supermicro C7B360-CB-M/MW Motherboard User’s Manual
7. Using a different system, extract the BIOS package into a USB ash
drive.
8. Press <DEL> continuously during system boot to enter the BIOS
Setup utility. Select and enter the "Save & Exit" main menu from
the left menu panel. Change the "Boot mode select" feature to the
UEFI option. From the boot option list, select Boot Option #1 as
shown below. Then, set UEFI Boot Option #1 to [UEFI AP:UEFI:
Built-in EFI Shell]. Press <F4> to save the settings and exit the
BIOS Setup utility.
9. When the UEFI Shell prompt appears, type fs# to change the device
directory path. Go to the directory that contains the BIOS package
you extracted earlier from Step 7. Enter ash.nsh BIOSname.### at
the prompt to start the BIOS update process.
Note: Do not interrupt this process until the BIOS ashing is
complete.
To Next Page
Loading...
