4-26
Supermicro C7Z170-SQ Motherboard User’s Manual
Ring Max OC Ratio
This option sets the maximum overclocking ratio for the RING domain.
Press "+" or "-" on your keyboard to change the value.
Ring Min OC Ratio
This option sets the minimum overclocking ratio for the RING domain.
Press "+" or "-" on your keyboard to change the value.
Uncore Voltage Offset
Use this feature to set the uncore domain Voltage Offset value from
-1000mV to +1000mV. Enter 0 to use the manufacture default value.
Press "+" or "-" on your keyboard to change the value.
Offset Prex
Use this feature to set the offset value as positive or negative. The op-
tions are + or -.
PCH Voltage
Use this feature to trim the PCH Voltage. Select from these values: 1.00V,
1.05V, 1.10V, 1.15V, 1.20V, 1.25V, and 1.30V.
CPU PLL Voltage
Use this feature to trim the CPU PLL Voltage. Select from these values:
1.20V, 1.25V, 1.30V, 1.35V, 1.40V, 1.45V, and 1.50V.
CPU_IO Voltage
Use this feature to calibrate the CPU I/O Voltage. Select from these val-
ues: 0.975V, 1.15V, 1.30V, and 1.50V.
Load Line Calibration
Load line calibration is vDroop, which is the tendency for a CPU's vCore
to drop when going from an idle state to a load state. Enable this feature
to reduce vDroop. The options are Disabled and Enabled.
VRM Total Current Limit Capability
Use this feature to set the CPU integrated voltage regulator when under
extreme high load for VRM total current limit. The options are 100%,
110%, 120%, 130%, 140%, 150%, 160%, 170%, 180%, 190%, and
200%.
To Next Page
Loading...
