Supermicro C9Z790-CG - Page 111

Chapter 4: UEFI BIOS
111
GT - Power Management Control
Note: This submenu becomes congurable when the installed CPU has built-in inte-
grated graphics.
GT - Power Management Control
RC6 (Render Standby)
Use this feature to enable Render Standby support. The options are Disabled and En-
abled.
Maximum GT Frequency
This feature denes the Maximum GT Frequency. Choose between 100MHz (RPN) and
1200MHz (RP0). Any value beyond this range will be clipped to its min/max supported
by the CPU. The options are Default Max Frequency and 100MHz - 1200MHz (in incre-
ments of 50MHz).
*If this feature above is set to Default Max Frequency, the following feature will
become available for conguration:
Disable Turbo GT frequency
This feature disables Turbo GT frequency. If set to Enabled, Turbo GT frequency be-
comes disabled. If set to Disabled, GT frequency limiters will be removed. The options
are Disabled and Enabled.
SATA And RST Conguration
SATA And RST Conguration
SATA Controller(s)
This feature enables SATA device(s). The options are Disabled and Enabled.
*If this feature is set to Enabled, the following features will become available for
conguration:
Storage Option ROM/UEFI Driver
This feature controls the execution of UEFI and legacy storage OpROM. The options are
Do not launch and EFI.
Aggressive LPM Support
This feature enables the PCH to aggressively enter link power state. The options are
Disabled and Enabled.