42
Super C9Z790-CG/-CGW User's Manual
2.7 Front Control Panel
JF1 contains header pins for various buttons and indicators that are normally located on a
control panel at the front of the chassis. These connectors are designed specically for use
with Supermicro chassis. Refer to the gure below for the descriptions of the front control
panel buttons and LED indicators.
Note: You can connect the S-Connector that came with your motherboard to JF1.
The S-Connector is a plug designed to connect the front control panel header on the
motherboard and front control panel cables of the chassis. Please align the printed
indications on the S-Connector with the corresponding pins on JF1 when plugging in.
Refer to the checklist table in Section 1.1 and contact Supermicro for more detailed
connector information.
C9Z790-CGW
DESIGNED IN USA
REV:1.00
MAC CODEMAC CODE BAR CODE
BIOS
LICENSE
PCH
JLED_POGO2
JLED_POGO1
JRLED2
JRLED1
JTPM1
JLED_IO
SW1
JSTBY1
JD1
JSD1
JPW1
LED4801
LED18
LED17
LED1
LED3
LED2
JPW2
JL1
LED4
JPME2
JLED1
SYS_FAN1
SYS_FAN2
JWD1
22110
22110
2260
2280
PCH SLOT1 PCIe 3.0 X1
USB12 (3.2, 20Gb)
USB7 (3.2, 20Gb)
USB6 (3.2, 10Gb)
M.2-C1
12V_PUMP_PWR1
USB9 (3.2, 20Gb)
USB8 (3.2, 10Gb)
2280
SP1
B1
2260
2260
2280
BOOT LED
VGA LED
DIMM LED
CPU LED
DP/HDMI
LAN2
LAN1
JF1
AUDIO FP
COM1
USB4/5
USB10/11
(3.2, 5Gb)
M.2-P1
PCH SLOT5
PCIe
3.0 X1
CPU SLOT4
PCIe
5.0 X8 (IN X16)
CPU SLOT7
PCIe
5.0 X16
M.2-P2
SYS_FAN3
HD AUDIO
USB0/1/2/3
POWER
BUTTON
DIMMB1
DIMMB2
DIMMA1
DIMMA2
RESET
BUTTON
CPU_FAN1 CLEAR CMOS
CPU_FAN2
I-SATA4
I-SATA5
I-SATA2
I-SATA3
I-SATA0
I-SATA1
M.2-E1 (CNVi)
Power Button
Overheat/
Fan Fail LED (-)
2
NIC1 LED (-)
Reset Button
1
HDD LED (-)
POWER LED (-)
Reset
PWR
POWER LED (+)
Ground
Ground
X
X
HDD LED (+)
NIC1 LED (+)
Overheat/
Fan Fail LED (+)
1615
NIC2 LED (-)
NIC2 LED (+)
To Next Page
Loading...
