Supermicro C9Z790-CG - Page 120

Super C9Z790-CG/-CGW User's Manual
120
COM1 Stop Bits
A stop bit indicates the end of a serial data packet. Select 1 (Stop Bit) for standard serial
data communication. Select 2 (Stop Bits) if slower devices are used. The options are 1
and 2.
Flow Control
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by bu󰀨er overow. Send a "Stop" signal to stop sending data when the receiving bu󰀨er
is full. Send a "Start" signal to start sending data when the receiving bu󰀨er is empty. The
options are None and Hardware RTS/CTS.
COM1 VT-UTF8 Combo Key Support
Check the box to enable VT-UTF8 Combination Key support for ANSI/VT100 terminals.
The options are Unchecked and Checked.
COM1 Recorder Mode
Check the box to capture the data displayed on a terminal and send it as text messages
to a remote server. The options are Unchecked and Checked.
COM1 Resolution 100x31
Check the box to enabled for extended terminal resolution support. The options are
Unchecked and Checked.
COM1 Putty KeyPad
This feature selects the settings for Function Keys and KeyPad used for Putty, which
is a terminal emulator designed for the Windows OS. The options are VT100, LINUX,
XTERMR6, SCO, ESCN, and VT400.
COM1 Redirection After BIOS POST
Use this feature to enable or disable legacy console redirection after BIOS POST. When
set to Bootloader, legacy console redirection is disabled before booting the OS. When
set to Always Enable, legacy console redirection remains enabled when booting the OS.
The options are Always Enable and Bootloader.
Serial Port for Out-of-Band management/ Windows Emergency
Management Services (EMS)
Console Redirection
Check the box to use a COM port selected by you for EMS Console Redirection. The
options are Checked and Unchecked.