53
Chapter 2: Installation
M.2 Sockets
This motherboard has three M.2 sockets. M.2 was formerly known as Next Generation
Form Factor (NGFF) and serves to replace mini PCIe. M.2 allows for a variety of card sizes,
increased functionality, and spatial eciency. Refer to the table below for more information.
Sockets Bus Interface Form Factors RAID Levels
M.2-P1 (from PCH) PCIe 3.0 x4 2260, 2280, and 22110 0, 1, and 5
M.2-P2 (from PCH) PCIe 3.0 x4 2260, 2280, and 22110 0, 1, and 5
M.2-C1 (from CPU) PCIe 4.0 x4 2260 and 2280 0, 1, and 5
SATA Ports
Six Serial ATA (SATA) 3.0 connectors (I-SATA 0 - 5) are supported on the motherboard. These
I-SATA 3.0 ports are supported by the Intel Z790 PCH chip (supports RAID 0, 1, 5, and 10).
SATA ports provide serial-link signal connections, which are faster than the connections of
Parallel ATA.
Note: For more information on the SATA HostRAID conguration, please refer to the
Intel SATA HostRAID user's guide posted on our website at https://www.supermicro.
com/support/manuals/.
1. M.2-P1
2. M.2-P2
3. M.2-C1
4. I-SATA0/1
5. I-SATA2/3
6. I-SATA4/5
C9Z790-CGW
DESIGNED IN USA
REV:1.00
MAC CODEMAC CODE BAR CODE
BIOS
LICENSE
PCH
JLED_POGO2
JLED_POGO1
JRLED2
JRLED1
JTPM1
JLED_IO
SW1
JSTBY1
JD1
JSD1
JPW1
LED4801
LED18
LED17
LED1
LED3
LED2
JPW2
JL1
LED4
JPME2
JLED1
SYS_FAN1
SYS_FAN2
JWD1
22110
22110
2260
2280
PCH SLOT1 PCIe 3.0 X1
USB12 (3.2, 20Gb)
USB7 (3.2, 20Gb)
USB6 (3.2, 10Gb)
M.2-C1
12V_PUMP_PWR1
USB9 (3.2, 20Gb)
USB8 (3.2, 10Gb)
2280
SP1
B1
2260
2260
2280
BOOT LED
VGA LED
DIMM LED
CPU LED
DP/HDMI
LAN2
LAN1
JF1
AUDIO FP
COM1
USB4/5
USB10/11
(3.2, 5Gb)
M.2-P1
PCH SLOT5
PCIe
3.0 X1
CPU SLOT4
PCIe
5.0 X8 (IN X16)
CPU SLOT7
PCIe
5.0 X16
M.2-P2
SYS_FAN3
HD AUDIO
USB0/1/2/3
POWER
BUTTON
DIMMB1
DIMMB2
DIMMA1
DIMMA2
RESET
BUTTON
CPU_FAN1 CLEAR CMOS
CPU_FAN2
I-SATA4
I-SATA5
I-SATA2
I-SATA3
I-SATA0
I-SATA1
M.2-E1 (CNVi)
5 64
1
2
3
To Next Page
Loading...
