Supermicro H11DSi-NT - Page 70

H11DSi / H11DSi-NT User's Manual
70
UTF8 encoding to map Unicode characters into one or more bytes. The options are VT100,
VT100+, VT-UTF8, and ANSI.
Bits per Second
This item sets the transmission speed for a serial port used in Console Redirection. Make
sure that the same speed is used in the host computer and the client computer. A lower
transmission speed may be required for long and busy lines. The options are 9600, 19200,
57600, and 115200 (bits per second).
Flow Control
Use this item to set the ow control for Console Redirection to prevent data loss caused
by buffer overow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xoff.
Data Bits
Parity
Stop Bits
PCIe/PCI/PnP Conguration
This menu provides PCIe/PCI/PnP conguration settings and information.
PCI Bus Driver Version
Above 4G Decoding
This setting Enables or Disables 64-bit capable devices ability to be decoded in above 4G
address space (only if the system supports 64-bit PCI decoding).
SR-IOV Support
If the system has SR-IOV capable PCI-E devices, this setting will Enable or Disable the
Single Root IO Virtualization Support for the system.
PCIe Spread Spectrum
Use this setting to Enable or Disable PCI-E Spread Spectrum for your system.
Target Link Speed
If supported by hardware and set to Force to x.S GT/S (x being a value of 2.5, 5.0 or 8.0) for
Downstream Ports, this sets an upper limit on Link Operational Speed by restricting the values