H13SAE-MF QUICK REFERENCE GUIDE
1. Locate the pre-installed stando and
screw. Remove the screw and set it
aside.
2280 M.2 Device Installation
M.2 Device Installation
2. Using a hex socket screwdriver, re-
move and then re-install the stando
to the position of the 2280 mounting
hole.
3. Insert the M.2 device into the M.2
socket at a 30-degree angle and press
it down.
4. Tighten the screw to secure the M.2
device into place. Do not overtighten
so as to avoid damaging the M.2 de-
vice.
To Next Page
Loading...
