4-9
Chapter 4: MicroBlade Module Features
Hard Disk Drives
The MBI-6219G-T7LX /MBI-6119G-T7LX MicroBlade module accommodates one (1)
2.5" SATA3 HDD/SSD SATA3 HDD/SSD drive per node. The drives cannot be removed
or replaced without powering down the blade unit they reside in. See Chapter 1 for
information on RAID Setup.
WARNING: Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro Web site
at http://www.supermicro.com/products/nfo/storage.cfm.
Blade Power Consumption Page
Using the Web-based Management Utility from the CMM module you may use the
System Health - Blade Power Consumption page to view graphs and other information
about the power consumption of each MBI-6219G-T7LX /MBI-6119G-T7LX blade in
your system (Figure 4-8).
For more details on the Web-based Management Utility see http://www.supermicro.com/
products/superblade/management/ on the Supermicro Website.
Figure 4-8. System Health - Blade Power Consumption Page
To Next Page
Loading...
