MBI-6219G-T7LX /MBI-6119G-T7LX MicroBlade Module User’s Manual
1-2
1-2 Blade Module Features
Table 1-1 lists the main features of the MBI-6219G-T7LX /MBI-6119G-T7LX MicroBlade
module. See the proceeding section for components typically included in a blade system
and other optional components. Specific details for the MBI-6219G-T7LX /
MBI-6119G-T7LX MicroBlade module are found in Chapter 4: "MicroBlade Module
Features" on page 4-1. The only difference between the two MicroBlade modules is that
the MBI-6119G-T7LX MicroBlade module has one node and the B2SS1-MTF
serverboard, while the MBI-6219G-T7LXMicroBlade module has two nodes and the
B2SS2-MTF serverboard.
Processors
The MBI-6219G-T7LX /MBI-6119G-T7LX MicroBlade module supports one E3-1500 V5
series processor in an FCBGA1440 socket embedded in the serverboard for each node.
Refer to the Supermicro web site for a complete listing of supported processors (http://
www.supermicro.com/products/microblade). Please note that you will need to check the
detailed specifications of a particular blade module for a list of the CPUs it supports.
Details on installation of the processor into the MBI-6219G-T7LX /MBI-6119G-T7LX
MicroBlade module are found in Chapter 3: " Setup and Installation" on page 3-1.
Memory
Each of the MBI-6219G-T7LX /MBI-6119G-T7LX MicroBlade module’s nodes have two
(2) FCBGA1440 DIMM sockets that can support up to 32 GB SODIMM of DDR4 2133
MHz speed, 16 GB size SODIMM memory. Memory is interleaved, which requires both
modules to be of the same size and speed.
Table 1-1. MBI-6219G-T7LX /MBI-6119G-T7LX MicroBlade Module
Specification Features
Serverboard
B2SS1-MTF (MBI-6119G-T7LX), B2SS2-MTF (MBI-6219G-T7LX)/
(proprietary form factor)
Blade System Enclosures MBE-628E-420/820
Chassis Specifications
Chassis Dimensions (HxWxD): 1.2" x 4.94" x 23.2" (30.48-mm x
125.476-mm x 589.28-mm), Gross Weight: 7.5 lbs (3.4 kg)
Processors
One (1) Intel
®
Xeon
®
E5-2600 V3/V4 embedded processor in an FCB-
GA1440 socket on the serverboard
Chipset Intel C236
BIOS 128 MB SPI Flash EEPROM with AMI® BIOS
Memory Capacity
Supports up to 32 GB SODIMM DDR4 2133 MHz speed and 16 GB size
SODIMM memory in two (2) FCBGA1440 DIMM sockets
Hard Drive Bays
The blade module supports one (1) 2.5" SATA3 HDD/SSD disk drive per
node. Additionally, two (2) M.2 and one (1) SATA-DOM connectors are
also available per node.
To Next Page
Loading...
