3-5
Chapter 3: Setup and Installation
DIMM Installation
Caution: Exercise extreme care when installing or removing SODIMM modules to prevent
any possible damage.
Installing/Removing SODIMM Memory Modules
1. Power down the MicroBlade module (see "Powering Down a MicroBlade Module
Unit" on page 3-1).
2. Remove the MicroBlade module from the enclosure.
3. Position the SODIMM module's bottom key so it aligns with the receptive point on
the slot (Figure 3-4).
Table 3-1. Memory Population Guidelines
P1/P2/P3/P4-DIMMA1 P1/P2/P3/P4-DIMMB1 Total System Memory
2GB 2GB
2GB 2GB 4GB
4GB 4GB
4GB 4GB 8GB
8GB 8GB
8GB 8GB 16GB
16GB 16GB
16GB 16GB 32GB
Figure 3-4. Aligning the SO DIMM
To Next Page
Loading...
