MBI-6219G-T7LX /MBI-6119G-T7LX MicroBlade Module User’s Manual
3-6
4. Insert the SODIMM module vertically at about a 45 degree angle (Figure 3-5).
5. Press down until the module locks into place. The side clips will automatically
secure the SODIMM module, locking it into place (Figure 3-6).
6. Power up the blade unit (see "Powering Up a MicroBlade Module Unit" on
page 3-1).
7. To Remove: Use your thumbs to gently push the side clips near both ends away
from the module. This should release it from the slot. Pull the SODIMM module
upwards.
Figure 3-5. Inserting the SO DIMM
Figure 3-6. Securing the SO DIMM in Place
Press down until
the module locks
into place.
Insert this end first
To Next Page
Loading...
