Supermicro SuperServer 5019A-12TN4 - Page 41

41
Chapter 4: Motherboard Connections
Power Fail
The Power Fail LED connection is located on pins 5 and 6. Refer to the table below for pin
denitions.
PWR Fail
Pin Denitions (JF1)
Pins Denition
5 3.3V
6 Power Fail
OH/Fan Fail LED
Connect an LED cable to pins 7 and 8 of JF1 to use the Overheat/Fan Fail and UID LED
connections. The blue LED on pin 7 works as the front panel UID LED indicator. The red
LED on pin 8 provides warnings of overheating, fan failure or power failure. The red LED
takes precedence over the blue LED by default. Refer to the tables below for pin denitions.
UID LED
Pin Denitions (JF1)
Pins Denition
7 UID LED
8 OH/Fan Fail LED
UID LED
Color and Status
Color Status
Blue: On Unit Identied
Power LED
Pin Denitions (JF1)
State Denition
O󰀨 Normal
On Overheat
Blinking Fan Fail
NIC1/NIC2 (LAN1/LAN2)
The NIC (Network Interface Controller) LED connection for LAN port 1 is located on pins
11 and 12 of JF1, and the LED connection for LAN Port 2 is on Pins 9 and 10. NIC1 LED
and NIC2 LED are 2-pin NIC LED headers. Attach NIC LED cables to NIC1 and NIC2 LED
indicators to display network activities. Refer to the table below for pin denitions.
LAN1/LAN2 LED
Pin Denitions (JF1)
Pins Denition
9/11 +3.3V Stby
10/12 LAN Activity LED