Supermicro SuperServer 5019A-12TN4 - Super Io Configuration; Serial Port 1 Configuration

Chapter 6: BIOS
67
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unied Extensible
Firmware Interface) for network stack support. The options are Enabled and Disabled.
*If "Network Stack" is enabled, the following four features are available for conguration:
IPv4 PXE Support
Use this feature to enable Ipv4 PXE Boot Support. If this feature is disabled, it will not create
the Ipv4 PXE Boot option. The options are Disabled and Enabled.
IPv6 PXE Support
Use this feature to enable Ipv6 PXE Boot Support. If this feature is disabled, it will not create
the Ipv6 PXE Boot option. The options are Disabled and Enabled.
PXE boot wait time
Use this feature to select the wait time to press the ESC key to abort the PXE boot. The
default is 0.
Media detect count
Use this feature to select the wait time in seconds to detect LAN media. The default is 1.

Super IO Conguration
Super IO Chip AST2400

Serial Port 1 Conguration
Serial Port 1
Select Enabled to enable the onboard serial port specied by the user. The options are
Enabled and Disabled.
Device Settings
This item displays the base I/O port address and the Interrupt Request address of a serial
port specied by the user.
Note: This feature is hidden when Serial Port 1 is set to Disabled.
Serial Port 1 Change Settings
This feature species the base I/O port address and the Interrupt Request address of Serial
Port 1. Select Auto for the BIOS to automatically assign the base I/O and IRQ address to
a serial port specied. The options are Auto, (IO=3F8h; IRQ=4), (IO=3F8h; IRQ=3, 4, 5,
6, 7, 9, 10, 11, 12), (IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12); (IO=3E8h; IRQ=3, 4, 5, 6,
7, 9, 10, 11, 12), and (IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12).