Supermicro SUPERSERVER 5019S-MT - Ports; Rear I;O Ports

4948
Chapter 4: Motherboard ConnectionsSuperServer 5019S-MT User's Manual
Universal Serial Bus (USB) Ports
There is one USB 2.0 port (USB0/1) and one USB 3.0 port (USB6/7) located on the I/O back
panel. The X11SSH-TF also has two front access USB 2.0 headers (USB2/3 and USB4/5)
and one front access USB 3.0 header (USB9/10). USB8 header is a USB Type A header. The
onboard headers can be used to provide front side USB access with a cable (not included).
4.3 Ports
Serial Ports
Two COM ports (COM1 & COM2) are provided on the motherboard. Both are located near
the PCI-E slot 4.
Rear I/O Ports
See the gure below for the locations and descriptions of the various I/O ports on the rear
of the motherboard.
SATA Ports
The X11SSH-TF includes a total of eight SATA 3.0 ports, supported by the Intel C236 PCH
chip. These SATA ports support RAID 0, 1, 5, and 10.
Figure 4-2. Rear I/O Ports
LAN Ports
There are two LAN ports (LAN1/LAN2) on the I/O back panel. There is also a dedicated IPMI
LAN port on the I/O back panel. These ports accept RJ45 type cables. Please refer to the
LED Indicator section for LAN LED information.
Rear I/O Ports
# Description # Description
1. COM Port 6. USB6 (3.0)
2. IPMI Dedicated LAN 7. LAN1
3 USB1 8 LAN2
4 USB0 9 VGA Port
5. USB7 (3,.0)
1 9876
5
4
3
2
Front Panel USB 2.0
HeaderPinDenitions
Pin# Denition Pin# Denition
1 +5V 2 +5V
3 USB_N 4 USB_N
5 USB_P 6 USB_P
7 Ground 8 Ground
9 Key 10 NC
Back Panel USB (3.0)
PinDenitions
Pin# Denition Pin# Denition
A1 VBUS B1 Power
A2 D- B2 USB 2.0 Differential Pair
A3 D+ B3
A4 Ground B4 Ground of PWR Return
A5 StdA_SSRX- B5 SuperSpeed Receiver
A6 StdA_SSRX+ B6 Differential Pair
A7 GND_DRAIN B7 Ground for Signal Return
A8 StdA_SSTX- B8 SuperSpeed Transmitter
A9 StdA_SSTX+ B9 Differential Pair
USB Type A
HeaderPinDenitions
Pin# Denition Pin# Denition
1 VBUS 2 D-N
3 D-P 4 GND
5 Stda_SSRX-N 6 Stda_SSRX-P
7 GND_DRAIN 8 Stda_SSTX-N
9 Stda_SSTX-P 10 CG
11 CG 12 CG
13 CG
Serial Ports
There is one COM port (COM1) on the I/O back panel and one COM header (COM2) on the
motherboard.
VGA Port
The onboard VGA port is located next to LAN Ports 1/2 on the I/O back panel. Use this
connection for VGA display.