Supermicro SUPERSERVER 5019S-MT - Quick Reference Table

1514
SuperServer 5019S-MT User's Manual Chapter 1: Introduction
Quick Reference Table
Jumper Description Default Setting
JBR1 BIOS Recovery Pins 1-2 (Normal)
JBT1 CMOS Clear Open (Normal)
JI
2
C1/JI
2
C2 SMB to PCI-E Slots Enable/Disable Pins 2-3 (Disabled)
JPB1 BMC Enabled Pins 1-2 (Enabled)
JPCK1 LANCONF Flash Pins 2-3 (Disabled)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPME2 Manufacturing Mode Pins 1-2 (Normal)
JPTG1 10Gb LAN Enable/Disable Pins 1-2 (Enabled)
JVRM1 VRM SMB Clock (to BMC or PCH) Pins 1-2 (BMC)
JVRM2 VRM SMB Data (to BMC or PCH) Pins 1-2 (BMC)
JWD1 Watch Dog Pins 1-2 (Reset)
LED Description Status
LEDBMC BMC Heartbeat LED Blinking Green: BMC Normal
LEDPWR Onboard Power LED Solid Green: Power On
LE1 UID LED Solid Blue: Unit Identied
LE3 M.2 LED Blinking Green: Active
Connector Description
BT1 Onboard Battery
COM1/COM2 COM Port/COM Header
FAN1 ~ FAN5, FANA System/CPU Fan Headers (FAN1: CPU Fan)
IPMI_LAN Dedicated IPMI LAN Port
I-SATA0 ~ I-SATA7 Intel PCH SATA 3.0 Ports
I-SGPIO1/I-SGPIO2 Serial Link General Purpose I/O Headers
J24 M.2 PCI-E 3.0 X4 Slot
JD1 Power LED/Speaker Header (Pins 1-3: Power LED, Pins 4-7: Speaker)
JF1 Front Control Panel Header
JIPMB1 4-pin BMC External I2C Header (for an IPMI Card)
JL1 Chassis Intrusion Header
JOH1 Overheat LED Header
JPI
2
C1 Power Supply SMBbus I
2
C Header
JPWR1 24-pin ATX Power Connector
JPWR2 12V 8-pin Processor Power Connectors
Connector Description
JSD1/JSD2 SATA DOM Power Connectors
JSTBY1 Standby Power Header
JTPM1 Trusted Platform Module/Port 80 Connector
JUIDB1 UID Switch
LAN1/LAN2 LAN (RJ45) Ports
SLOT4 PCH PCI-E 3.0 X2 (IN X4) Slot
SLOT6 CPU PCI-E 3.0 X8 Slot
SP1 Internal Speaker/Buzzer
USB0/1 Back Panel Universal Serial Bus (USB) 2.0 Ports
USB2/3, USB4/5 Front Accessible USB 2.0 Headers
USB6/7 Back Panel USB 3.0 Port
USB8 USB Type A Header
USB9/10 Front Accessible USB 3.0 Header
VGA VGA Port