Supermicro SUPERSERVER 5028D-TN4T - Page 68

SUPERSERVER 5028D-TN4T User's Manual
5-6
Installing a Hard Drive into the Hard Drive Carrier
1. Remove the six screws which secure the dummy drive into the hard drive carrier.
2. Remove the dummy drive from the hard drive carrier.
3. Install a new hard drive into the hard drive carrier with the printed circuit board
side facing down so that the mounting holes in the drive align with those in the
carrier.
4. Secure the hard drive by tightening all six screws.
Figure 5-7. Installing a Hard Drive into Hard Drive Carrier
Hard Drive
Carrier
Dummy Drive
Hard Drive