Supermicro SUPERSERVER 5028D-TN4T - Installing the DVD Drive

SUPERSERVER 5028D-TN4T User's Manual
5-10
Installing the DVD Drive
1. Power down the system as described in Section 5-1 and remove the chassis
cover.
2. Unlock the front bezel and swing it open.
3. Remove the bracket for the top mounted xed hard drive, by removing the two
screws.
4. Remove the two screws securing the EMI grid to the front of the chassis.
5. Remove the EMI grid from inside the chassis, just behind the chassis front. If
you will later remove the DVD drive, save the EMI grid.
6. Remove the plastic DVD bay cover from the chassis front by carefully breaking
it out.
5-5 Installing the DVD Drive
The chassis supports one DVD drive. It can be installed only if the top mounted
xed HDD is not used. It requires a mounting bracket rail, pn MCP-220-81502-0N.
Figure 5-11. Conguring the Chassis for the DVD Drive
1
4
1
2
5
1
3