5-11
Chapter 5 Advanced Chassis Setup and Maintenance
Figure 5-13. Installing the DVD Drive
8. Slide the DVD drive into the chassis until it snaps into place.
9. Some DVD drives allow you to secure the drive with two screws.
10. Connect the SATA cable and the power cable to the DVD drive.
11. Close the front bezel, replace the chassis cover and power up the system.
7. Install the bracket rail (part number MCP-220-81502-0N) onto the left hand side
of the DVD drive, using the two screws provided.
Figure 5-12. Securing the Bracket Rail to the DVD Drive
Secure the DVD
Drive with Screws
(Optional)
1
8
1
9
Bracket Rail
1
7
To Next Page
Loading...
