5-15
Chapter 5 Advanced Chassis Setup and Maintenance
5-8 Replacing the Power Supply
The chassis includes a xed power supply. If it is necessary to replace the power
supply, follow the instructions below.
Changing the Power Supply
1. Power down the system as described in Section 5-1 and remove the chassis
cover.
2. Remove power cables from the motherboard, hard drives, and backplane.
3. Remove the screws securing the power supply to the chassis, which are located
on the rear of the chassis. Set these screws aside for later use.
4. Remove the power supply from the the chassis.
5. Replace the failed power supply with an identical model power supply.
6. Secure the new power supply using the screws previously set aside.
7. Reattach the power cables to the motherboard, hard drives, and backplane.
8. Replace the chassis cover, plug the power cord into the rear of the power supply
and power up the system.
Figure 5-17. Removing the Power Supply
Power Supply
To Next Page
Loading...
