47
Chapter 3: Maintenance and Component Installation
Installing Expansion Cards
Each node can accommodate two full-height, half length x8 PCIe cards per node, plus one
Installing a Full-Height Expansion Card
1. Power down the node and remove it from the chassis.
2. Loosen the release screw that holds the small rectangular cage that secures the PCI
shields, and slide the cage to the right (looking at the chassis rear).
3. Remove the blank PCI shield from the chassis.
4. Slide the expansion card shield into the open shield slot while plugging the expansion
card into the riser card.
5. Secure the expansion card shield by sliding the small cage back to left and tightening
the screw.
Figure 3-14. Installing the Expansion Cards
Low Prole Card
Shield Screw
Retention
Cage Screw
Riser Card
Shield
Retention Cage
Installing a Low Prole Expansion Card
Power down, remove the node, remove the shield screw, and insert the expansion card.
To Next Page
Loading...
