Supermicro SuperServer E300-9A-4CN10P - Page 28

28
SuperServer E300-9A-4CN10P User's Manual
Chassis Intrusion
A Chassis Intrusion header is located at JL1 on the motherboard. Attach the appropriate cable
from the chassis to inform you of a chassis intrusion when the chassis is opened. Refer to

Chassis Intrusion
Pin Denitions
Pin# Denition
1 Intrusion Input
2 Ground
General Purpose I/O Header

output pin. The GPIO is controlled via the PCA9554 8-bit GPIO expansion. The base address
is 0xF040(D31:F4).
JGP1 Header
Pin Denitions
Pin# Denition
1 +5V +5V
2 Ground Ground
3 GP0 GPP_E0
4 GP1 GPP_F1
5 GP2 GPP_E1
6 GP3 GPP_F2
7 GP4 GPP_E2
8 GP5 GPP_F3
9 GP6 GPP_F0
10 GP7 GPP_F4
Disk On Module Power Connector
The Disk-On-Module (DOM) power connector at JSD1 provides 5V power to a solid-state DOM

DOM Power
Pin Denitions
Pin# Denition
1 5V
2 Ground
3 Ground