Supermicro SuperServer E300-9A-4CN10P - Page 57

57
Chapter 5 BIOS
Network Stack

Firmware Interface) for network stack support. The options are Enabled and Disabled.
*If "Network Stack" is set to Enabled, the next four features will be available for
conguration:
Ipv4 PXE Support
Use this feature to enable Ipv4 PXE Boot Support. If this feature is disabled, it will not create
the Ipv4 PXE Boot option. The options are Disabled and Enabled.
Ipv6 PXE Support
Use this feature to enable Ipv6 PXE Boot Support. If this feature is disabled, it will not create
the Ipv6 PXE Boot option. The options are Disabled and Enabled.
PXE boot wait time
Use this feature to select the wait time to press the ESC key to abort the PXE boot. The
default is 0.
Media Detect Count
Use this feature to select the wait time in seconds to detect LAN media. The default is 1.

Super IO Conguration
Super IO Conguration
Super IO Chip AST2400

Serial Port 1 Conguration
Serial Port 1 Conguration
Serial Port 1
    
Disabled and Enabled.
Device Settings
This feature displays the base I/O port address and the Interrupt Request address of a
