Supermicro SuperServer E300-9A-4CN10P - Page 70

70
SuperServer E300-9A-4CN10P User's Manual
When SEL is Full
This feature allows the user to determine what the BIOS should do when the system event
log is full. Select Erase Immediately to erase all events in the log when the system event
log is full. The options are Do Nothing and Erase Immediately.
Note󰀨
restarted in the BIOS setup menu.
BMC Network Conguration
The following features will be displayed:
IPMI LAN Selection
This feature displays the IPMI LAN setting. The default setting is Failover.
IPMI Network Link Status:
This feature displays the IPMI Network Link status. The default setting is Shared LAN.
Update IPMI LAN Conguration
Select Yes for the BIOS to implement all IP/MAC address changes at the next system boot.
The options are No and Yes.
*If the feature above is set to Yes, Conguration Address Source and VLAN will
become available for conguration:
Conguration Address Source
Use this feature to select the source of the IP address for this computer. If Static is selected,
you will need to know the IP address of this computer and enter it to the system manually in

Protocol) server in the network that is attached to and request the next available IP address
for this computer. The options are DHCP and Static.
The following features are assigned IP addresses automatically if DHCP is selected, or

Station IP Address
This feature displays the Station IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This feature displays the sub-network that this computer belongs to. The value of each
three-digit number separated by dots should not exceed 255.