Supermicro SuperServer E300-9A - Page 58

SuperServer E300-9A User's Manual
58

I-SATA (M.2)
This following information is displayed:
• Device Information
• Device Size
I-SATA (M.2) Enable/disable port
Use this feature to disable or enable the SATA port number. The options are Enabled and Disabled.
I-SATA (M.2) Spin up
When the value of an edge detect or the value of an image binary (pixel) of a device is from 0 to 1, select Enabled to
allow the PCH to start a COMRESET initialization sequence on this device. The options are Enabled and Disabled.

SATA1
SATA 1 Enable controller
This item enables or disables the onboard SATA controller supported by the Intel PCH chip.
The options are Enabled and Disabled.
SATA 1 LPM (Link Power Management)
When this item is set to Enabled, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods
of I/O inactivity and will return the link to an active state when I/O activity resumes. The
options are Enabled and Disabled.
*If the feature above is enabled, the SATA 1 ALPM feature is available for conguration:
SATA 1 ALPM
Use this feature to disable or enable the Aggressive Link Power Management. The options
are Enabled and Disabled.
SATA 1 SGPIO/LED
Use this feature to select the SATA LED or SGPIO LED. The options are SGPIO and SATA
LED.

I-SATA0 ~ I-SATA3, mSATA
This following information is displayed for each SATA drive entry:
• Device Information
• Device Size