Supermicro SuperServer E300-9D-4CN8TP - Page 55

Chapter 5: UEFI BIOS
55
CPU T State Control
Software Controlled T-States
Use this feature to enable Software Controlled T-States. The options are Disable and
Enable.
Chipset Conguration
Warning: Setting the wrong values in the sections below may cause the system to malfunction.
North Bridge Conguration
Memory Conguration
Enforce POR
Select POR (Plan of Record) to enforce POR restrictions on DDR4 frequency and volt-
age programming. The options are POR and Disable.
Memory Frequency
Use this feature to set the maximum memory frequency for onboard memory modules.
The options are Auto, 2133, 2400, and 2666.
Data Scrambling for DDR4
Use this feature to enable or disable data scrambling for DDR4 memory. The options
are Auto, Disable, and Enable.
tCCD_L Relaxation
Select Auto to get TCDD settings from SPD (Serial Presence Detect) and implement into
memory RC code to improve system reliability. Select Disable for TCCD to follow Intel
POR. The options are Disable and Auto.
Enable ADR
Select Enable for ADR (Automatic Diagnostic Repository) support to enhance memory
performance. The options are Disable and Enable.
2X REFRESH
Use this feature to select the memory controller refresh rate to 2x refresh mode. The
options are Auto and Enable.