Supermicro SuperServer E300-9D-4CN8TP - Page 62

62
SuperServer E300-9D-4CN8TP/E300-9D-8CN8TP User's Manual
*If the feature "Congure SATA as" above is set to RAID, the following features will be
available for conguration:
SATA RSTe Boot Info
Select Enable to provide full int13h support for the devices attached to SATA controller. The
options are Disable and Enable.
SATA RAID Option ROM/UEFI Driver
Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
SATA Port 0~7
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
• Model number of drive and capacity
• Software Preserve Support
Port 0~7 Hot Plug
Set this feature to Enable for hot plug support, which will allow the user to replace a SATA
drive without shutting down the system. The options are Disable and Enable.
Port 0~7 Spin Up Device
On an edge detect from 0 to 1, set this feature to allow the PCH to initialize the device.
The options are Disable and Enable.
Port 0~7 SATA Device Type

Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
PCH sSATA Conguration
When this submenu is selected, the AMI BIOS automatically detects the presence of the
SATA devices that are supported by the Intel PCH chip and displays the following features:
sSATA Controller
This feature enables or disables the onboard sSATA controller supported by the Intel PCH
chip. The options are Enable and Disable.
Congure sSATA as

AHCI
and RAID.