Chapter 5: UEFI BIOS
65
1. Enable AMI Native Support in the Advanced > NVME Firmware Source menu.
2. After the installation is complete, enable Boot Option 1 for the NVMe device. Go to
Boot > UEFI Hard Disk Drive BBS Priorities > Boot Option # 1 > NVMe device.
3. Boot > Boot Option #1 > NVMe device.
VGA Priority
Use this feature to select VGA priority when multiple VGA devices are detected. Select On-
graphics card. The options are Onboard
to give priority to your graphics card, please follow the steps below:
PCI-E 3.0 X16 or CPU SLOT6 PCI-E 3.0 X8.
JMD2: M.2-H PCI-E 3.0 X2 lane 1 Type
Use this feature to select which option for the add-on card in this slot. The options are PCIE
and USB 3.0.
Note 1: The default setting for M.2 B key is PCIE. If you want to support M.2 B key with USB
3.0 signal, please follow the steps below:
> USB3.0.
Notes 2: SATA devices can be supported regardless of the BIOS setting (USB3.0 or PCIE).
CPU SLOT6 PCI-E 3.0 X16 OPROM
Use this feature to select which option for the add-on card in this slot. The options are
Disabled, Legacy, and EFI.
CPU SLOT7 PCI-E 3.0 X8 OPROM
Use this feature to select which option for the add-on card in this slot. The options are
Disabled, Legacy, and EFI.
JMD1: M.2-HC PCI-E 3.0 X4 OPROM
Use this feature to select which option for the add-on card in this slot. The options are
Disabled, Legacy, and EFI.
JMD2: M.2-H PCI-E 3.0 X2 OPROM
Use this feature to select which option for the add-on card in this slot. The options are
Disabled, Legacy, and EFI.
PCI-E 3.0 X1 OPROM
Use this feature to select which option for the add-on card in this slot. The options are
Disabled, Legacy, and EFI.
To Next Page
Loading...
