Chapter 2: Installation
2-11
Note: For optimized airow, please follow your chassis airow direction
to properly install the heatsink. Graphic drawings included in this manual
are for reference only. They might look different from the components
installed in your system.
OPEN 1st
Screw#1
Screw#2
Installing a Passive CPU Heatsink
1. Do not apply any thermal grease to the heatsink or the CPU die -- the re-
quired amount has already been applied.
2. Place the heatsink on top of the CPU so that the four mounting holes are
aligned with those on the Motherboard and the Heatsink Bracket underneath.
3. Screw in two diagonal screws (i.e., the #1 and the #2 screws) until just snug
(-do not over-tighten the screws to avoid possible damage to the CPU.)
4. Finish the installation by fully tightening all four screws.
Mounting Holes
Direction of the
airow
To Next Page
Loading...
